Trinity Racing Can-Am Maverick X3 Slip-On Exhaust

INSTALLATION INSTRUCTIONS

1. REMOVE THE REAR PLASTIC OEM SHROUD.
2. REMOVE THE STOCK EXHAUST SYSTEM FROM THE TURBO BACK.
3. REMOVE THE OEM MUFFLER PLATE FROM THE FRAME. SAVE THE 4 OEM GOLD LAG
BOLTS.
4. TRIM THE OEM HEATSHIELD BACK TO THE BOLT TAB FOR TAIL PIPE CLEARANCE.
5. INSTALL THE TRINITY HEAD-PIPE TO THE TURBO FLANGE UTILIZING THE STOCK COUPLER.
6. INSTALL THE TRINITY MUFFLER MOUNTING BRACKET USING 4 OEM LAG BOLTS.
7. ATTACH THE 4-BOLT FLANGES ONTO THE MUFFLERS WITH THE BOLT ON SPRING
RETENTION TAB ON THE OUTSIDE TOP LOCATION ON EACH MUFFLER.
8. LOOSELY PRE ASSEMBLE THE MUFFLERS WITH THE 2 PIECE MOUNTING CLAMPS.
9. SLIDE THE TRINITY Y-PIPE INTO THE 4 F BOLT FLANGES ON THE MUFFLERS.
10. USING THE BUTTON-HEAD ALLEN BOLTS AND WASHERS ATTACH MUFFLERS TO THE
MOUNTING BRACKET. INSTALL THE BOLTS FROM THE BACK SIDE OF BRACKET.
11. INSTALL THE TRINITY Y-PIPE TO THE HEAD PIPE.
12. TIGHTEN ALL HARDWARE ON ENTIRE SYSTEM.
13. REINSTALL YOUR OEM SHROUD AND HEAT SHIELDS. (LIGHT TRIMMING NEAR EXHAUST TIP AREA IS RECOMMENDED)
14. BEFORE STARTING VEHICLE, CLEAN ALL EXHAUST COMPONENTS TO REMOVE ANY FINGER PRINTS OR OIL RESIDUE.